Application inside apartment stairwells, corridors, elevator halls, kindergartens, hotels, hospitals, officetels, etc.

- Application equipment : Use only the Decotex spray gun or bontile spray
- Color : 20 Colors
- Specific gravity : 1.00 ± 0.03
- Drying time : 12 hours (Temperature 22-25℃, humidity within 50%)
- Thinning (dilution rate) : water, not more than 20%
- Theoretical Quantity For Application : 2 – 2.5 ㎡ / L
- Shelf life : 6 months (5-35℃ indoor storage)
- Packing unit : 18 kg / Plastic Pail

■ Application Conditions
- Painting surface: Concrete, Cement, Gypsum board, Lightweigh beam Building, etc
- Surface preparation: Remove moisture, oil, rust, soil, and other dirt from the coating and fill the grooves or cracks with putty before sanding.

■ Painting procedure
1) Base Coat
- After cleaning the background, check that there is no dust or foreign substances on the surface, and paint it 1-2 times using a roller, brush, or spray gun to absorb and penetrate the work surface.
- If necessary, dilute the clean water to less than 5-10% according to the painting conditions.
- If the surface of the painting is heavily absorbed or the surface of the painting is insufficient during a single painting, additional paint shall be applied.
2) Middle Coat
- After painting the base coat at 25℃ for at least 24 hours, check the dryness and paint the middle coat.
- Before use, stir the paint contents evenly. (Never stir with an electric mixer)
- If necessary, dilute the clean water to less than 5-10% according to the painting conditions. (Never mix organic solvents)
- When painting the middle coat, paint the nozzle with a diameter of 3 to 5 mm and a injection pressure of 2.5 to 3.5 kgf/cm².
- Injection paint tools (exclusive guns) should be painted at a distance of 50 to 60cm perpendicular to the painting surface.
- When painting, the color and pattern formation may differ from the sample depending on the painting pressure, painting speed, painting distance, painting equipment, etc. of the worker, so make sure to use it after the test painting.
3) Top Coat
- After painting the middle coat at 25℃ for at least 24 hours, check the dryness and paint it with a roller, brush, and spray gun to absorb and penetrate the work surface.
(Please keep in mind that dry hardening time may vary depending on the change of season.)
- If workability is required, dilute clean water to less than 10-15% and paint it once or twice.

- Do not mix with other paints.
- Dilute the water to form an appropriate pattern and stir it evenly with a stick. Please refrain from stirring by the machine because the pattern is destroyed.
- Even if it's the same color, the pattern and color may vary slightly depending on the worker, painting method, painting condition, and painting distance.
- Be careful because painting and contacting the surface containing plasticizer, foam wallpaper, and leather sofa may cause contamination, stickiness, and discoloration.
- Do not freeze the paint (storage temperature is 5-35℃)
- It shall be stored in a place where it can be protected from direct sunlight and bad weather between 5°C and 35°C. Keep the remaining amount in the same way after use, but use it as soon as possible.
- Avoid painting on rainy or humid days (over 85% relative humidity) and low temperature days (below 5°C). (Cracks, poor adhesion, etc. of the coating film may occur)
- Please check the suitability of the old coating film for repair and painting on top of the old coating film.
- Dispose of waste paint in accordance with relevant laws.